19 results for “Supervisory Control Systems Buying Leads, Buyers & Importers”

We are looking for these products: 1) Required generator sizes (same manufacturer) Unit 1 (Single phase): 7 to 8 kilovolt-ampere rated output 230 volt, 50 hertz, single phase Silent canopy Unit 2 (Three phase): 15 to 20 kilovolt-ampere rated output (18 preferred) 400 volt, 50 hertz, three phase Silent canopy Both units must be supplied by the same factory and preferably the same platform family. 2) Full autonomous start requirement (non-negotiable) Both units must start and stop automatically with: Two-wire dry contact start input terminals for automatic transfer switching No key fob remote start as the primary method Designed for unattended standby operation 3) Controller input and output signals (non-negotiable) Controller must provide at minimum: Start input Running status output Alarm or fault output Fault log preferred 4) Standby cold-start logic (non-negotiable) Automatic glow plug and preheat control Reliable cold start without manual intervention 5) Power quality and step-load performance (non-negotiable) Stable voltage and frequency suitable for inverter and battery charger loads Must tolerate step-load without stalling or unstable speed hunting 6) Noise target (non-negotiable) 70 decibels or less at 7 metres at 50 percent load Must be silent canopy type 7) Fuel system requirement (non-negotiable) Fuel filtration including water separator Serviceable filterwhile in field use - Trade term: EXW (factory) first, later FOB. - Payment term: sample order by T/T 100%. Production: 30% deposit, 70% before shipment (negotiable for larger orders). - Quantity: 1–2 samples first, then 20–50 units per order, scaling to 100+ units. Destination port: Brisbane, Australia. - Trade terms are irrelevant if the offered products do not meet the required specifications. Petrol generators EFI is the required hard technical gate. Carburettor and choke systems are inherently unreliable after standby periods and are therefore not acceptable for unattended operation. This requirement is clearly stated in the petrol RFQ: EFI is mandatory, unless the manufacturer can provide documented, factory-proven evidence of a system designed and validated for reliable unattended starting. Diesel generators Proper glow plug and preheat logic is the required hardware and control requirement. “Electric start” alone is not sufficient if the controller does not execute temperature-based preheat, start retry logic, and fail-to-start alarms. These requirements are explicitly defined in the diesel RFQ and the acceptance protocol.

We are seeking experienced Smart City and Smart Lighting solution providers for a Joint Venture (JV) partnership for upcoming urban infrastructure projects. Scope includes: Smart LED Street Lighting IoT-based Remote Monitoring & Control Systems Smart Poles (CCTV, WiFi, EV Charging integration optional) Energy Management & Smart Metering Command & Control Center Integration We are open to EPC contractors, technology providers, system integrators, and investors for long-term collaboration. Preferred partners should have: Proven government or municipal project experience CE / RoHS / IEC certifications Smart City deployment track record Interested companies may share company profile, past project references, technical specifications, and partnership proposal. We are looking for strategic JV collaboration for pilot and large-scale deployment. Connect mail@stratumjurisnexus.com, www.stratumjurisnexus.com

We are seeking reliable copper scrap suppliers and cold rolling mill technology providers for a Joint Venture industrial project. Scope 1 – Copper Scrap Supply: Millberry (99.9%) preferred Birch / Cliff Heavy copper scrap Monthly volume: 500–2000 MT Clean, non-contaminated material only SGS inspection required Scope 2 – Cold Rolling Technology: Copper strip & coil production line Thickness range: 0.2mm – 3mm (customizable) Complete rolling mill setup including: Rolling stands Annealing furnace Slitting line Quality control systems We are open to: Long-term supply agreements Technical collaboration Equity-based Joint Venture partnership Serious manufacturers and direct suppliers only. Industrial land and project planning in progress. Long-term expansion toward integrated copper processing and export. Connect mail@stratumjurisnexus.com www.stratumjurisnexus.com

Send your quotation based on the importer’s request below: Product: Xanthan Gum Application: Oil and gas drilling fluid systems Compliance: Meets technical standards for rheology control, viscosity enhancement, and filtration loss reduction in water-based muds Quantity: 1 20 ft container Trade Term: CIF Payment Term: T/T or L/C Required Documents: Certificate of Analysis, MSDS, Packing List, Invoice Target Price: Negotiable

Product : Xanthan Gum Specifications: For Use In Oil And Gas Drilling Fluid Systems. The product must meet technical standards for rheology control, viscosity enhancement, and filtration loss reduction in water-based muds. Quantity:1 20 ft container Required Documents: Certificate of Analysis, MSDS, Packing List, Invoice Packaging Terms : 25kg bags or 1-ton jumbo bags; Quantity: 1 twenty-foot container; Trade term: CIF; Payment term: T/T or L/C; Target Price: Negotiable;

Hello, We need refined sunflower oil Specifications: Sunflower oil for human consumption with SRO certification of This product. With A legal confirmation, that the SRO is without gene technology and/or Genetical Manipulations, from factories with a permanent quality control systems. In one Litre bottles (PET), with labels access according the wishes of the buyer and Bottle Caps with a open and close system; According to the following chemical composition: Please put the analysis of the RSFO: Commodity: RSFO, for human consumption , Quantity : 12 deliveries with each 4000 MT Packet into1000 ml PET bottles, 12 or 15 bottles/ carton, with approx. 22 MT per container for shipping First delivery: acc agreement Contract duration: 12 months, with possibility for prolongation Origin: EU or ...... Transport cost included to any port in Moldavia or Rumania Price: CIF per MT : 820 acc. NCNDA + IMFPA, which will be a part of the contract . Delivery : CIF Moldavia or Rumania . Payment: irrevocable conf. L/C, direct between Seller and Buyer , not transferable. Payable against: Invoice, packing list, goods analysis, B/L certificate, In this case, the buyer has the possibility to visit the Oil Mill or the PET Filling station and get the POP, that the RSFO is available. Alternatively: The payment will be done after second SGS control in the unloading port . Perf. Bond: The seller will open a 2% Performance Bond The seller will send immediately the FCO Best Regards, "ERSLA" Company

Kindly send a quotation based on the following request from the importer:

Send your quotation based on the importer’s request below: A quantity of 600 units of Presostato DSK-1 Orange for automatic control and pressure regulation in hydraulic systems. Payment term: Letter of credit up to 1 year. Destination port: Valparaiso. Incoterms: CIF.

Product : Xanthan Gum Specifications: For Use In Oil And Gas Drilling Fluid Systems. The product must meet technical standards for rheology control, viscosity enhancement, and filtration loss reduction in water-based muds. Quantity:1 20 ft container Required Documents: Certificate of Analysis, MSDS, Packing List, Invoice Packaging Terms : 25kg bags or 1-ton jumbo bags; Quantity: 1 twenty-foot container; Trade term: CIF; Payment term: T/T or L/C; Target Price: Negotiable;